Base for Kent Double Morse Paddle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My Kent Double Paddle had a habit of sliding around the desk on the existing rubber feet.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 672
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
My Kent Double Paddle had a habit of sliding around the desk on the existing rubber feet. Also I didn't like the give in the rubber feet.
So I designed this plate so that there is a flat surface on the bottom of the key. It attaches with the M3 screws from the rubber feet. If you print in TPU it might be sticky enough, however I also printed the associated thin Mat which can be stuck down to the surface with double sided tape and provides a rough surface for the plate to sit on. Alternatively stick a sheet of thin rubber to the plate. In that case, it should be possible to print it in PLA.
The cutouts were made for my own arrangement where I have another 3.5mm socket to plug in a computer keyer or a straight key - my Elecraft K2 can detect this with the aid of some diodes which are in the black heatshrink.
Print instructions
I used 0.2mm layers with generic TPU. I sliced it with the SemiFlex profile in PrusaSlicer 2.2.0 at 15% infill.