Under-the-Table Discrete Remote Holder with Honeycomb Sides
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remote control holder with honeycomb sides and bottom. Mounts to the underside of a desk or table.
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 147
- Wydruki
- 1
- Wyświetlenia
- 673
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution
This is a remote control holder that mounts to the underside of a desk or table. It has honeycomb sides to save on some filament.
It mounts with the 4 tabs on the top of the model. The 4 holes directly below the tabs are to allows access for a screwdriver to reach the screws to secure the holder.
The longer hole on the bottom is for access by fingers if a small remote gets pushed to the back and cannot be easily pushed out. That way you can nudge it forward without having to get between the honeycomb holes.
I printed with 0.20mm layer height with PETG and supports for the mounting tabs. The support material was a pain to clear away from the honeycomb holes but I believe it is necessary for the tabs.