Electric skateboard tyre
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tyre to encase a hard rubber skateboard wheel 52mm width x 70mm diameter.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 474
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
This tyre is designed to print with TPU. The purpose of it is to make your board ride smoother and in slippery surfaces like snow, soil or grass.
A fusion360 file is attached in case you want to make modifications to the design.
The grooves on the tyre V1 are inspired in cyberpunk style. But these can be a little loud.
V2 grooves are smaller and should run quieter.
V3 grooves are even better, more frequent and have shown better grip.
I recommend using the same infill % / infill pattern / wall count, as this part is key. Less infill % will result in higher friction as the tyre will bend inwards easier, reducing the acceleration from the skateboard. Infill % of 25% or more is recommended.
On my Ender 6 these were print settings that worked:
- TPU from reprapper
- Infill: 25% or more
- Infill pattern: Gyroid
- Wall count: 5
- 35 mm/s
- bed: 60 C
- Nozzle 220 C
- retraction off
- support material only on the base of the wheel, with blockers on other areas.