1 / 11
TomTom Rider GPS mount and GoPro mount for it — zdjęcie 1
1 / 11

TomTom Rider GPS mount and GoPro mount for it

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount a slimmed-down TomTom Rider into a GPS mount and mount a GoPro into the Rider mount

Ocena
0 / 5
Polubienia
6
Pobrania
25
Wydruki
0
Wyświetlenia
554
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

2023.04 update: the holes for the gopro mount apparently created a stress-riser or something and the mount snapped off, I'm pretty sure glueing it on would work (and will likely repair mine with glue unless I decide to mount the gopro completely elsewhere).

2023.04 update2: It seems on bumpy roads the GoPro Max360 is too heavy for the TomTom spring and the camera starts bouncing wildly. So now I have mounted the Max elsewhere with a stiff mount.

 

The rotating base for the TomTom Rider mount is a bit thick so I made a part that replaces the rotation part with a slimmer piece that has holes for CNCKitchens heat-set thread inserts.

And also a piece that mates with the release-lever on the rider mount that fits the GoPro quick-release base.

The specific GPS mount I made this for is https://iconicparts.uk/shop/ols/products/multistrada-screen-brace-spacer-gps-mount-winglet-combo but really anything that can handle the screw-pattern will do (and you can download the Fusion360 designs and adjust things.

Instructions: remove the middle round place with 6 small Torx screws from the back of the Rider mount, replace with the tomtom_adapter model, I was afraid that the screws would not reach the threads so it might be a bit loose fit, add hot-glue if you feel like it.

To help with overhang issues in the middle the model has a thin (2 layers) part in the middle that needs to be cut out.

For the gopro plate mount place it on the lever and drill holes for M3 screws, I then made the holes a bit bigger and put in M3 heat-set thread inserts and screwed it in tight. Your M3 screws need to be pretty short, I only had M3x16 ones so I dremeled them down to approx 8-10mm length

To release the GPS you need to push the lever more straight back than down.

Printed in Colorfab NGen on Prusa MK3+MMU2S in single color mode so.

 

Fusion 360 designs: 

Tagi