Raspberry pi camera adapter for stereo microscope eyepieces
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter for use a cheap Raspberry pi camera for a stereo microscope pr microscope of 32-33mm diameter eyepieces.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 110
- Wydruki
- 0
- Wyświetlenia
- 1169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an adapter for the raspberry pi camera (rev 1.3; you can get it for 3-4 USD on Aliexpress) and is used to put it on the eyepieces of any stereo microscope with 32-33mm diameter. It has spaces so as not to press on the microcomponents that the circuit has and 2 holes for M3 screws, to be fixed with more force to the eyepiece if necessary (in my case it was very well attached without these). There are 2 lengths in case the focal length of your microscope is different. There is also an internal margin that limits the glass of the eyepiece from touching the camera and scratching it.
-PLA (I use Creality CR-PLA, black)
-Recommended layer high: 0,1mm ( but 0,2mm also works)
-No supports needed
-10-50% infill recommended
Others:
-4 (2 are fine also) M2 screws for fixing the camera to the adapter
-2 M3 screws for fixing the adapter to the eyepiece (just if necessary)
-Print upside down (with the opening facing up)