YAREK - Yet Another Rotary Encoder Knob - The Series
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A beefy rotary encoder knob intended for use on the Prusa control panel; usable anywhere with the same shaft dimensions.
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 396
- Wydruki
- 5
- Wyświetlenia
- 1632
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Have you ever stared at your clumsy meat mittens and thought, "you know, what I need here is a thicc rotary encoder knob". Yeah, probably not, but I did and made a couple that came pretty close to what I was looking for.
These will clear the build plate with no problem.
There are two versions so far and they are as follows:
/YAREK v.1/ - this one is a thick, heavily knurled knob with a nice dish in the middle.
/YAREK v.2/ - similar to v.1, but isn't knurled. Instead this one is smooth with a exaggerated groove (which is the best description I can think of) that you can use to quickly jog the dial with your finger.
If for some reason I come up with any more ideas, I'll upload and add them here.
Print instructions
These printed well without any supports. I tried to design them so that they would.
I personally printed them in PETG using the .15mm Quality setting and 3 perimeters.