90° Overhang Challenge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For me this gcode doesn't turn off heating after printing is complete, so don't leave the printer unattended.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 47
- Wydruki
- 1
- Wyświetlenia
- 782
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
Printed on a modded Anet A8.
Interesting thing happens when the next stem is being printed, the hanging layer immediately curls upwards. Top layer (one without stem above) stays perfectly flat.
Despite this, I would like to see similar approach to bridge generation in PrusaSlicer. Also in association with minimalistic pin supports.
Gcode parameters:
Nozzle: 0.4mm, Overlap: 4%, Overhang: 90°, XY scale: 200%, Feedrate: 260%, PLA 205°C/30°C
Printing time: 13:11
For me this gcode doesn't turn off heating after printing is complete, so don't leave the printer unattended.