Cable Duct / Cable Channel / Mounting Box / Installation Housing / Kabelkanal Brüstungskanal Geräteeinbaudose

Please leave a Like :-)

This is a Remix of https://www.thingiverse.com/thing:3517496

I Just constructed a 3x Box and some Mounts aditional.

I also designed a "Slide in and Rotate Clip" with Notches to hold the Box or to Screw it in Place.

Because of the gaping when inserted the Clip, Box will also be holded by the edges.

What ever - with this Clip you will have oportunities and a solid solution for heaviest forces.

I added a Clip to mount Powersupplys inside the Duct - Standard LED PSU and PSU from Meanwell.

The Design is best printed like shown in the picture - otherwise the supports are a lot and heavy to remove.

I also recomend to set the support blockers as shown.

Also set the density of the support roof to Lines, z gap 0.4 and 40% roof density.

Infill 30 % did it for me.

Perfect Print !

I also recomend to screw the outlets in and not to spread it with the claws because of stresses on layer adhesion.

Print Settings

Printer:

FLSUN Q5

Rafts:

Supports:

Yes

Resolution:

Infill:

30

Filament:

Tronxy PLA

White

Category: Replacement Parts