1 / 2
RPi4B Profile Mount Case Remix for Pimoroni Fanshim
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of a remix here. First, I ran the bottom through netfabb which resolved a lot of errors.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 146
- Wydruki
- 1
- Wyświetlenia
- 1671
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (2)Kolekcje (40)Powiązane
Remix of a remix here. First, I ran the bottom through netfabb which resolved a lot of errors. Second, I remixed the top to significantly short the screw pole closest to the GPIO pins. This allows one to use a Pimoroni Fanshim inside the case.
The photo was printed in Fillamentum Vertigo Gray PLA at on "0.20mm Speed" profile in PrusaSlicer with 100% infill.