Apollo Era Crawler center floor Sections in 1/60 and 1/72 scale
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here are of .8mm thick floor sections for the center floor area of the Apollo Era Crawler.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 307
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are .8mm thick floor sections for the center sections of the Apollo Era Crawler. They have the vent holes already in place. Minor trimming may be needed to get the vent parts to fit.
All four parts are the same so double check your orientation before you start printing. If you want a slick floor, print them upside down and glue them in place with the bottom up. The edge with 2 holes goes towards the center. The with the single hole goes towards the front or back end of the Crawler. The floor vent parts are not included.
Unfortunately, not all printers print the same. Dry fit and adjust as needed with your slicer of choice. These were printed on a Prusa I3 mk3S, .2mm line thickness and 3 perimeters and Aligned Rectilinear for the top fill pattern.