1 / 2
VICTORIAN MANSION ROOF RAFTERS HO (1/87th) SCALE — zdjęcie 1
1 / 2

VICTORIAN MANSION ROOF RAFTERS HO (1/87th) SCALE

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the final part to the build.

Ocena
0 / 5
Polubienia
47
Pobrania
177
Wydruki
0
Wyświetlenia
529
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution

This is the roof rafters of the VICTORIAN MANSION model. Depending on your printer, some components may require some minimum minor trimming. 

I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two pieces of printed scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on stryene and PLA for years. No sloppy or messy glue to show when finished. This build is the attic floor only, the roof rafters are currently in the design/test phase. 

If you would like me to design a custom model for you contact me at: 

[email protected]. 

It is totally free but I will post it on Prusa Printables for others to print and enjoy.

Tagi