1 / 2
Cardboard Spool Rim Only - Remix for California Filament PETG — zdjęcie 1
1 / 2

Cardboard Spool Rim Only - Remix for California Filament PETG

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the cardboard spool rim only for California Filament PETG cardboard spools.

Ocena
5 / 5
Polubienia
18
Pobrania
96
Wydruki
1
Wyświetlenia
1108
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Edge rim only for card board spools. This is a quick remix to fit for the California Filament PETG cardboard spools. There are three versions included that work equally well. The 4.4 mm is a tight fit, matching the cardboard spool thickness and can prove difficult to place on the spool edge. The 5.0 mm is a bit loose in my opinion. The 4.6 mm is a compromise.

I recommend printing in PETG. It is strong and flexible for this installation. I'm not certain PLA would work without breaking when trying to install. If you print the rings with ABS, shrinkage may require scaling in X and Y for fit. For my ABS test, 0.5% (1 mm) in X and Y resulted in the expected fit.

These rings print quickly, stay in place, and are effective at protecting the spool edges. The edge ring was sized in the design for a 0.2 mm layer height

For the Bambu Lab AMS they address the issue of dust and roller wear from the spool edges.

Tagi