Booty Bobbler

Make sure to like and rate the file if you found it useful! Tips are also appreciated if you'd like to see more files from me or if you would like to request changes or updates to files!

A goofy bobblehead where the bobbles are booty cheeks.

Assembly:

• Print one base: gives the model stability, but can stand on its own without the base.
• Print one body: Can be printed mostly without supports. Supports should be manually added, if able, to the following areas:
  • teeth, chin, ponytail overhang
  • both hands, drink can
  • front of skirt, rear/under skirt

• Print two springs: one left and one right. I recommend you print 2-3 sets of springs in case you damage or lose any of them during assembly. You can slice the spring vertically  in your slicer to reduce the spring power. I recommend cutting at 0.5mm to 1.0mm if your spring is too strong.
• Print two leg pieces, left and right.
• Assemble the springs into the knees and leg pieces. The side of the spring with the small nub goes into the knee. You will likely need to sand the spring pins. They should fit tightly and take slight effort to press into place.

• Attach the model to the base. You can use 3mm screws or the pin file provided.

Good luck! I'll be test printing and assembling mine. Let me know if you're having issues so I can fix them.

Check Out Some of My Other Files
Springy Trick or Treat Toys	Linkable Tupperware Lid Holder	2.5" SSD to 3.5" SATA Bay Adapter