Magic Wand with alternative bottom
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remake of the Magic Wand with Secret Compartment with an easier to print buttom part.
- Ocena
- 4,75 / 5
- Polubienia
- 43
- Pobrania
- 342
- Wydruki
- 4
- Wyświetlenia
- 1512
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the magic wand remixed with a modified bottom. I found the original hard to print (stringing and uneven surface). This remix adds an additional partial cone at the bottom, which provides a larger flat surface and steeper lower perimeter. No other modification was made.
Print Instructions
These are printer specific, your mileage may vary.
I have also used FreeCAD to add embossed text with the childrens' names on the wands. Watching a FreeCAD tutorial helped (add a cone that aligns with the magic wand at the place where you want the text, reduce the angle to 180° or less, then project the text on the round surface. Play with padding height of text to get the emboss effect).
I have printed them in Prusament PETG Galaxy Black. The sparkles made a nice effect and I liked it more than a jet black test print.
| Printer | Mk3s+ |
| Filament | Prusament PETG |
| Infill | 100% on top, 25% on other parts |
| Supports | None |
| Scale | 90% (otherwise too large for this printer model, scale all parts) |
| Brim | 8mm for handle and top (tip and bottom print fine without) |
Use 100% infill to avoid easy breaking (tried at 25% before but made them rather brittle).