Extremely Strong Samsung Soundbar Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made to mount my Samsung Sound Bar behind my new TV
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 69
- Wydruki
- 1
- Wyświetlenia
- 547
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution
Made to mount my 2016 Samsung Sound Bar behind my new TV, and ran some Fusion tests on it, and turns out it can support upwards of 15 pounds when mounted properly. I recommend using two for redundancy and to support it better, but you probably could get away with just one. Use 2" drywall screws or similar.
Recommended print settings
Print on its side, because that significantly reduces the time it takes to print, and also cuts down on cost.
Infill:
No less than 20%, Gyroid highly encouraged
Rafts:
None
Brim:
None
Supports:
Yes
Material:
Printed mine in PETG, but if you were gonna use these for something heavier, use ASA or PC
Perimeters:
I went with 4 on mine, however this is up to you (I recommend 3+)
Print Time:
About 5 hours a piece, uses $2.45 worth of (PETG) filament
Full Disclosure, I took the picture as soon as I finished the print, so I didn't have the Sound Bar installed on it yet. Please don't sell these:)