1 / 6
Therm-a-Rest Pump Sack WingLock Inflator DIY (non flex!) — zdjęcie 1
1 / 6

Therm-a-Rest Pump Sack WingLock Inflator DIY (non flex!)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a "do it yourself" solution for a pump bag to inflate the new Therm-a-Rest air mattresses (e.g. NeoAir XLite).…

Ocena
0 / 5
Polubienia
15
Pobrania
159
Wydruki
0
Wyświetlenia
1228
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a "do it yourself" solution for a pump bag to inflate the new Therm-a-Rest air mattresses (e.g. NeoAir XLite).

What to do?

  1. print both parts
  2. take any bag and cut a small hole in it.
  3. put part 1 (body) through the hole from the outside.
  4. screw part 2 (lid) to part 1 from the inside.
  5. Finished.

I added an additional grid inside to prevent dirt from the bag from getting into the mat.


GERMAN:

Es handelt sich hierbei um eine "Do it yourself"-Lösung für einen Pump Sack zum Aufpumpen der neuen Therm-a-Rest Luftmatratzen (z.B. NeoAir XLite).

Was ist zu tun?

  1. Beide Teile ausdrucken
  2. Eine beliebige Tüte zur Hand nehmen und ein kleines Loch hinein schneiden.
  3. Teil 1 (Body) von außen durch das Loch stecken.
  4. Teil 2 (Lid) von innen mit Teil 1 verschrauben.
  5. fertig.

Ich habe innen zusätzlich ein Gitter hinzugefügt, damit kein Dreck aus der Tüte in die Matte gelangt.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

15%

Filament: extrudr PLA (Green-Tec) black

Category: Sport & Outdoors

Tagi