Digitech RP360 XP Wah Pedal Stopper/Spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacer to allow the wah pedal to be pressed without switching into volume mode. Sized so a hard press can switch modes.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
72 mm between centre of bottom bumps.
It's very easy on the pedal to accidentally switch modes between effects and volume, this prevents that.
Printed it at 25% infill, and it had just enough flex to allow a hard press to still switch modes, but if you wanted to disable that, printing it at a higher infill with less flex would prevent that. As it is, I assume this will be a wearable part over time as it gets stepped on and slightly crushed each time.
I have also included a version 1 that is thicker and presumably stronger. I did not print it, because it felt like it had extraneous material and I made it smaller so it would print faster as version 2.