Spool Holder - Ender 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Yet another spool holder. It has a fast, 2-start thread (16mm pitch) for quick loading and unloading. The end bearing…
- Ocena
- 4,5 / 5
- Polubienia
- 70
- Pobrania
- 330
- Wydruki
- 3
- Wyświetlenia
- 2249
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Yet another spool holder. It has a fast, 2-start thread (16mm pitch) for quick loading and unloading. The end bearing is smaller to allow for a unthreaded lead for easier threading.
The thread tooth has 45 degree sides so it prints great, especially the internal threads.
You will need :
1 - 22x8x7mm roller bearing (608)
1 - 16x8x6mm roller bearing (688)
1 - 150mm M8 bolt or threaded bar
2 - M8 nuts.
2 - 8mm Washers
Tighten the M8 bolt to apply some preload to the bearings so that the reel does not run freely if jerked.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
20
Filament: CCDIY PLA+ Any
Notes:
You'll only need supports for the bearing bore on the screw part.
Category: 3D Printer Accessories