RuuviTag dev board mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Proudly presenting a mount for the RuuviTag dev board. Didn't like using a zip tie to fix a tag on the board,…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Proudly presenting a mount for the RuuviTag dev board.
Didn't like using a zip tie to fix a tag on the board, switching tags sucked so I developed this mount.
Sizes are adjusted to my printer and settings to get a perfect fit.
If you have problems with them just edit the parts to fit your needs:
base: https://a360.co/2XN06yu
clamp: https://a360.co/2OoCwoS
For the curious: the board case is this https://www.thingiverse.com/thing:2538889
What I also did, not shown in the pictures, was smelting the small pins of the base when mounted to the board to really fix it. That way it also stays in place, if you remove the dev board from the nRF52DK. Maybe with a hot iron but put some baking paper in between just like when smelting those pearls for kids (most parents should know what I am talking about)...
Print Settings
Printer Brand:
Ultimaker
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.1 and 0.2 mm
Infill:
30%
Filament:
Colorfabb PLA/PHA
Notes:
Base and nut 0.1mm layer height and clamp 0.2mm.
Category: Tools