OpenBuild limit switch (end stop) mount for Sphinx Z-axis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created this limit switch (end stop) mount for the Sphinx Z-axis to move the switch from the front to the side of…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 719
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
I created this limit switch (end stop) mount for the Sphinx Z-axis to move the switch from the front to the side of the axis.
I only have one router and need to unmount it every now and then. The default L-bracket, mounted on the front of the Z-axis) makes it more tricky to remove the router and left a few deep scratches. By moving it to the side there's much more wiggle room when (un)mounting the Router
Print instructions
The 3 components are modelled so that no supports are needed and with optimal layer direction if you place them in the correct orientation on the print bed.
I printed this in PLA at 0.2mm layer hight without supports. Rotation might be needed if you use the individual .stl files.
If you bought an OpenBuilds kit, you should already have all needed mounting hardware. Otherwise, you'll need:
1x Tee nut M5 (536-Pack / 819368021646)
2x Low profile (8mm) M5 screw (110-pack / 819368021820)
1x Xtension Limit Switch Kit (obviously) (2805-Kit / 819368027747)