1 / 1
Mount Unifi UAC-AC-Pro to a tube/pole
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount a Unifi UAC-AC-Pro to a 35mm tube/pole.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 43
- Wydruki
- 2
- Wyświetlenia
- 439
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
This is for mounting an Unifi UAC-AC-Pro to a 35mm tube or pole. The original mounting bracket is not required, this mount uses the inner, smaller bayonett joint of the AP. I've built this for my UAC-AC-Pro, but it may work for other Unifi AP as well.
Printing should be easy, no supports required. Part 1 may need supports if printed with a filament with bad bridging properties. I've used PLA for indoors and didn't need supports.
For assembling five M4x20 Allen/Torx screws are required:
- Screw part 1 & 2 to the tube using four M4x20 screws.
- Slot in AP into part 1 and turn into position.
- Insert part 3 and secure it with another screw.
- Done