Lasercut base for MK3S+ electronics and PSU with room for dampening foam and paver tile
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Built to support the BLV enclosure (https://www.printables.com/model/73738-blv-enclosure-beta)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 338
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I purchased a BLV enclosure kit (https://www.printables.com/model/73738-blv-enclosure-beta), but didn't want to leave my PSU and electronics inside, so designed a lasercut base for the enclosure to hold the PSU and electronics.
It is designed so you can rest a foam dampening mat and paver tile inside the base for the printer to sit on (see photos).
The base has the PSU attached to the outside so you easily disconnect the power cable and turn the machine on/off with the switch on the PSU. The controller is connected to the outside as well.
Inside the base there's room for two 80mm fans, the einsy, raspberry pi 3 (the W's are currently unobtainable so I repurposed the pi3 from my old printer), led driver (for the cob leds which I put in the enclosure) and two voltage convertors (one for the pi, one for the fans).
The led driver output goes to a DC connector so the enclosure can be easily detached.
And all einsy, heatbed, and extruder wiring is connected through two XT60 and three 12 pin GX20 aviator connectors so the printer can be easily detached from the base as well.
I put a brace (https://www.printables.com/model/106678-mk3s-black-psu-replacement-brace) instead of the power supply.
And replaced the soft feet with rigid feet (https://www.thingiverse.com/thing:3082188) to rest the printer on the paving tile.
I also created a cable mount to be put in place of the einsy, to hold the extruder cable bundle in its place.