1 / 2
Bambu Magnetic Purge / Poop Bucket for X1C / X1 Carbon — zdjęcie 1
1 / 2

Bambu Magnetic Purge / Poop Bucket for X1C / X1 Carbon

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

My take on a magnetic purge / poop bucket for the Bambu Lab X1C.

Ocena
4,5 / 5
Polubienia
52
Pobrania
769
Wydruki
2
Wyświetlenia
4777
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

My take on a magnetic purge / poop bucket for the Bambu Lab X1C. This may also work on the non-carbon version (X1) however I do not know if the back of that is also metal or just plastic.

I have designed this to accept magnets, so the poop bucket will not tip over as it fills, the bucket will rest on a desk behind the printer. However, the magnets should be strong enough to hold the bucket suspended in air if you do not have desk space behind the printer.

I have also designed this to print-in-place, no supports needed, and print relatively quickly for the size.

Features

  • Magnetic, sticks on the back of the printer.
  • Thumb-hole for easier removal.
  • Large size to hold much poop, but not too large to take up lots of space.
  • Angled bottom to encourage poop to stack evenly.
  • Print-in-place, no supports needed.
  • Prints relatively fast, about 2 hours and 45 minutes on stock Bambu PLA profile @ 0.28mm layer height.
  • No Bambu logos (how many logos do we need?)

Hardware Required

  • This requires SIX (6) 5x6mm magnets, or TWELVE (12) 5x3mm magnets (glued together with superglue in pairs).

Print / Assembly Instructions

  1. Print on Bambu X1C, 0.28mm layer height profile. I printed it in PLA for speed, but you can also do PETG if you want a stronger and more durable bucket.
  2. Put the magnets in the holes. I recommend a little dab of superglue on the back of the magnets to ensure that they stay in there and never come out.
  3. The holes are sized, so the magnets should be able to press-fit in snugly, but without too much force. Depending on your filament calibration, you may need to widen the holes a little bit or definitely use superglue to keep them in if they go in too easy.
  4. Place on back of printer so the “doorway” on the bucket lines up with the poop chute on back of the Bambu printer.

Criticism / Warranty

I do not insure this design will work for your printer, but it works on mine. I am not a professional designer and I accept any and all constructive criticism, but please consider contacting me first with any suggestions before leaving less than 5 star review. Thanks!

Tagi