Laundry Bead Holder for Roomba 600 Series

Description
Having your floors vacuumed every day is nice but it can be even better! With newer Roombas like the i3 and the j7 you can place laundry beads between the filter and the mesh section in the bin and they will stay put and leave a nice smell while the Roomba vacuums. Sadly there's not a way to do this on the 600 Series Roombas due to their bin design, until today! (Or whenever you're reading this I guess.) This little attachment slides right in the Roombas air path and adds laundry beads so that you get the same effect as the i3 and j7 Roombas! Special thanks to my dad for showing me this trick!

Compatibility
Roomba 600 Series (Unsure on 680 and 690)

Installation
Step 1
Remove bin from robot.

Step 2
Flip bin over and remove the 6 screws holding the bin together

Step 3
Carefully remove clear plastic part of the bin from the black part of the bin. The bin should now be in 4 pieces 5 if you've removed the filter.

Step 4
Fill 3d printed piece with laundry beads of choice I liked the Downy UnStopables Fresh. Then add lid push all sides until it clicks

.

Step 5
Insert 3d printed piece into the fan out hole on the Roomba.

Step 6
Reassemble your Roomba's bin.
-Place the Plastic piece in making sure the side with more vents are facing towards the airflow out port and the clip lines up on the top
-Place back on the clear plastic piece making sure the screw holes align and the clips slide in the corrects spots.
-Screw in all 6 screws careful not to over tighten! (See above image for placement)
-Pop the dust guard back in by pressing firmly making sure its oriented correctly

Step 7
Reinsert your Roomba's bin and start cleaning!

Step 8
Enjoy!