Voron Formbot Connector Cover and 3 hole cable anchor at Clockwork 1 Extruder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Voron connector cover and 3 hole chain anchor to work with the components in the Formbot kit
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 806
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
The Formbot Voron Trident kit comes with a 3 hole cable chain and separate connectors for each device on the extruder. The Voron part for securing the cables doesn't work (its backwards and the screws are too short), so I modified chain_anchor_3hole.stl to add a zip tie anchor.
The Voron part for covering the connectors, [a]_connector_cover.stl, is too small for the Formbot connectors so I added 10 mm of volume to it with adjustments to avoid interference at the X end stop and cable chain. The support in the middle needs to be removed after printing.
cable_spacerV2 is for where the cables go from the print bed to the z cable chain so they are not going over the side of the first piece of the cable chain (see page 241 of Trident Assembly manual)
Edit - reduced the size of the front opening 12/31/2022 and added the small cable spacer.