Creality Sonic Pad Vesa Mount 1 piece

This is a single piece version of my other Sonic Pad Vesa mount. It mounts the pad higher up and closer to the mount so the connections will clear the plate. This allows for a more compact mount.

The bottom half of the Vesa plate will be visible which you can cover with a tool mounting plate if you wish. If your mount is smaller this may not be an issue.

CSPVMnt1pc.stl is the Sonic Pad Vesa mount. Use M3x8 or M3x10 screws to mount to the pad. Use M5 screws and Nuts to attach to Vesa mount. There are holes for both 100mm and 75mm mount spacings but you only need to use 2 screws.

VMnt_ToolHldrPlate.stl is the tool holder plate that can be mounted below the Sonic Pad. The holes are sized for M4 screws to cut their own threads. The hole spacing is based on this Gridfinity Wall mount: https://thangs.com/designer/the.d.i.y.tinkerer/3d-model/Gridfinity%204x1%20Wall%20Mount%20Base.stl-186980 The hole spacing is set up to use both odd and even numbered mounts. I tried some Gridfinity trays but they would not snap into the base properly so I gave up…

The other files are various tool mounts that I could think of. Of course the filament cutters and a USB drive holder. An Accelerometer mount just holds it by the cable.

You can design your own mounts, etc as needed. See dimension diagram for VMnt_ToolHldrPlate.stl for hole spacing details.

VMnt_CutterPeg.stl uses an M4x16 screw.

VMnt_USB Drive Holder.stl and Vmnt_Accel Mount.stl use M4x6 screws.

Also see another version of this which can mount 2 Sonic Pads to one mount. This bracket will not work for that purpose.

12/23/22: Added a glue stick holder for Elemer's 20mm diameter stick.