TFA Dostman mount for Prusa Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple bracket/mount for the TFA Dostman Thermo/Hygrometer.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
TFA Dostman Hygrometer?
Per the discussion on the Prusa Forum here.
Printing
I found it a tight fit for the nuts when printed in ASA (0.25 nozzle, 0.15) and a bit too loose when printed in PLA (0.25 nozzle, 0.15). The pockets for the magnets are really tight in both cases so you don't need glue (and can recover the magnets).
Magnets
This bracket contains two 2x6x20 magnets. You should have these already since there is a spare one included in the MK3S+ printer and another spare in the Prusa Enclosure kit.
North and South pole
The TFA Dostman already has magnets, so you could just put iron in the pockets. If you do put magnets in there, then remember to put them correctly poled! Otherwise they will reject the Hygrometer.
Improvement possible!
Adding half a mm (or 1 mm) to the depth will prevent the hygrometer from touching the door.
EDIT20221201: Currently printing a 1mm deeper version because it was uncomfortable to have the hygrometer touch the enclosure door. Attached this as a v2.0 stl.
Source and License
I have included the FreeCAD source for this model. I consider this public domain, though it would be nice to mention this page as the original source.