1 / 11
Ergotron LX Dual Arm Adapter for Samsung G9 (and other heavy monitor support) — zdjęcie 1
1 / 11

Ergotron LX Dual Arm Adapter for Samsung G9 (and other heavy monitor support)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dual 100x100/75x75 VESA Monitor Arm Adapter for SuperUltrawides (heavy) support

Ocena
0 / 5
Polubienia
4
Pobrania
18
Wydruki
0
Wyświetlenia
1545
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

If you own something like an Ergotron LX (Same as the Amazon Basics Premium dual monitor arm) and upgrade to one of those massive 49" super ultrawide like the Samsung G9 - you'll want to continue reading.  

The G9 is 26lbs and the max weight of a single monitor arm is 25lbs. This adapter plate combines both 100x100/75x75 combo monitor plates/mounts into one.  You fit this adapter on the two arm plates, then two of the 4 screws go through both plates into the monitor. This combines both arms and shares the weight and forces.  Use at your own risk, ideally this would be made out of metal but surprisingly PETG works pretty well.

Edit: over a year later, this continues to work without exception as my daily monitor & stand! 

I drilled out all the holes in the plastic to make them snug w/ a 3mm bolt. I ultimately used six 3mm shorter bolts and nuts w/ washers on both sides and snugged them all up. It is quite sturdy and the monitor mount for the Samsung fit perfectly, clearing the small bolts.  If you have a setup like mine and a 3d printer I think it's worth a shot unless you want to splurge for a heavy duty arm.  

Side note: you do need to ensure you “lock” at least one of the mounting plates (they rotate but there's a set screw to lock them squarely against the arm) the goal is to avoid any free rotation of one of the arms to maintain better stability, otherwise it may drift - but by using the arm's provided 3mm bolt you can fix one plate solid (so it cannot rotate) then the second mount can rotate a little and provide you some fine tuning adjustment.   

The backstory: 
In a moment of weakness, I stumbled across an epic seasonal discount for a Samsung 49" super ultrawide (32:9 ratio).  I already have an Ergotron LX dual arm monitor mount. I put my brand new 49" on one of the single arms and it was immediately evident, this was going to be too heavy (max weight for the arm is 25lbs).  I went to amazon for ideas and found heavy duty single arm stands from ergotron were $300-$450 USD, I had to find a better solution.  After doing some additional research I found the LX arms support two 27" heavier panels which added up to more weight than my 49" - so I started to brainstorm what it would look like to combine both the LX 100x100 mount plates together and combine both LX arms to support the weight (btw the Ergotron LX is identical to the Amazon basics premium dual arm - at least in the US).

Tagi