Share your heart (Vase mode (overhang test))
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Share your heart with someone you love. And bring your heart back together. Maybe during the holidays?
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 57
- Wydruki
- 1
- Wyświetlenia
- 597
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was printing a Christmas ornament in vase mode and my daughter loved it. So much so that she asked me if I could print her a heart the same way. So I sculpted this heart to share with her.
To make the halves magnetic use 2 (or more) magnets + gravity. Drop the magnets in the heart halves when they are printed and off the build plate. They will rattle a bit when the halves are alone.
I have printed the included Ender3S1 gcode file myself successfully on my Ender 3 S1 with 3DJAKE ecoPLA Glitter Purple.
Flow, perimeter width and temperature are the most important factors in printing this ornament. Below are the settings that worked for me. If the bottom overhang prints correctly you are good. Watch the first 3 minutes. If you get it right you can start increasing printing speed.
- Layer height 0.1 mm
- First layer height 0.3 mm
- Perimeters 1
- Spiral Vase
- Extrusion width perimeter 190%
- Extrusion multiplier (flow) 1.2-1.8
- Temperature at top end of recommended of your filament
I am sporting klipper with my Ender 3 S1 and print 2 heart halves in 50 minutes.