Tetrahex Puzzle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Geometric puzzle with ten pieces and a storage box with a sliding lid.
- Ocena
- 5 / 5
- Polubienia
- 91
- Pobrania
- 380
- Wydruki
- 5
- Wyświetlenia
- 1758
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Puzzles & Brain-teasers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
🧩 Tetrahex Puzzle
The puzzle consists of ten pieces and a storage box with a sliding lid. The puzzle pieces are used on both sides.
There are 12,990 solutions to the puzzle shape in the box and 167 to the snowflake shown. You can also create many other shapes.
🖨 Print Settings
Material: PLA · No supports · No raft or brim
You can print the snap-fit lid with either side on the print bed. For a nicer finish on the visible surface, place the top side face down.
You can ignore the slicer warning caused by the breakaway connection of the spring tabs underneath the lid.
🔧 Before Using the Lid for the First Time
Release both spring tabs before sliding the lid into the box. Otherwise, the lid may get stuck and become very difficult to remove.
Press the two spring tabs underneath the lid inward, one at a time, to release them. You should hear a small snap.
If a spring tab is difficult to release: Place a hard board on the table. Hold the lid on its edge and press the spring tab against the board to release it. Repeat for the other spring tab if needed.
The animation in the image gallery shows how to release the spring tabs.
💡 Tip for Better-Looking Puzzle Pieces
For a consistent finish on both sides, print two sets at half thickness. To do this, lower the pieces 2.0 mm into the build plate in your slicer, mirror one set, and glue the matching halves together.
🌐 More Polyform Puzzles and Background Information
🧩 More Polyform Puzzles on Printables
⚠ Safety Note
Choking hazard due to small parts. Not for children under 3 years.