MPSM V2 fan shroud remix

Thanks for the excellent fan mount from kbowley. I also liked the mounting design from tgeehan & keco185. Unfortunately both of these seem to cause uneven cooling with the 40mm fan. I have modified kbowley's design by adding a support arm over the hotend, adding a variable to elevate the blow ring as well as a few other minor changes. Unfortunately this means the model does need to be built with supports.

Update: added two versions, moreflow & XLflow. The first has a blow ring with a 2 mm larger diameter & the other has a larger air inlet. I have added photos of 3DBenchy with the original fan mount vs the "moreflow" version.

Note that the height is for an original E3D V6 all metal hot end, not the stock hot end.

Print instructions

Category: 3D Printer Accessories Summary

Thanks for the excellent fan mount from kbowley. I also liked the mounting design from tgeehan & keco185. Unfortunately both of these seem to cause uneven cooling with the 40mm fan. I have modified kbowley's design by adding a support arm over the hotend, adding a variable to elevate the blow ring as well as a few other minor changes. Unfortunately this means the model does need to be built with supports.

Update: added two versions, moreflow & XLflow. The first has a blow ring with a 2 mm larger diameter & the other has a larger air inlet. I have added photos of 3DBenchy with the original fan mount vs the "moreflow" version.

Note that the height is for an original E3D V6 all metal hot end, not the stock hot end.

Print Settings

Printer Brand: Dremel Digilab

Printer: 3D40

Supports: Yes

Resolution: 0.1

Infill: 85

Filament: Dremel PLA Black
Notes:

Print with the fan mount on the build plate. It printed with Cura's new tree supports touching build plate only.