Model Aleron Rocket

Hello fellow rocket engineers!

I have made a rocket capable of flying high whilst spinning. It uses two alerons to spin located near the bottom of the fins. Have you ever wondered what a it would look like if you cross a rocket with a plane? Well now its time to take your rocketeering hobby to the next level and assemble my rocket, it has taken a lot of hard work to design and i hope you appreciate all of the efforts i have gone to… It is made to fly with any 18mm or 0.7in rocket motor from Estes sutch as a B-64… Enjoy!

Parts to print;

Nosecone v2 x1 

Wing strengthener x4

Engine tube bracket x2

Aleron flap next gen v2 x2

Tube wing bracket v3 x2

Engine cover x1

Parts to laser cut (or cut by hand like i did);

Wing right v2 x1

Wing left v2 x1

Fins large x4

Fins small x2

Parts to buy;

Estes body tubes BT-55

Parachute 18inch

Estes engine hooks standard

Engine tube (A,B,C Motor)

Balsa wood

Print settings;

Layer height: 0.15mm

Supports: No

Rafts: No

Infill: 2%

Perimeters/Walls: 2

(This is an experimental rocket that has not been tested as of yet, If you complete this project try at your own risk, I will post when i've tested the rocket but that will be in a couple of months)

4.5.2023 - 

I have finally tested the rocket and I can confirm that it works a treat! Flew as predicted and a stable flight!

I will link .step files below to show how to assemble the parts ;-)

Dimensions; H 58.5, L 24.2, D 14.2

I will post the rocket stand i used as a sperate model

Happy Printing & Flying! 🚀