Contemporary lamp with clear PLA diffuser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The unfinished cement and floating shade give this lamp an industrial high-tech look with literally millions of colors.
- Ocena
- 0 / 5
- Polubienia
- 31
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 1112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This project will use cement casting and neopixel LEDs to create a funky bedside lamp. It utilizes the WLED firmware in an 8266 so you can connect it to your DMX system or maybe sync it with your PC RGB light setup. If that is not enough why not ask Google assistant to turn it on? Do you have home assistant? WLED is good to go with MQTT as well. The extensibility allows many other features such as sound reaction.
All the wiring is hidden within this contemporary design for a nice clean finish and a modern upgrade to a major award.
Lamp shade
The lampshade should be printed with clear PLA for the best effect. When printing use the low-quality setting and turn off retraction and have no supports. This will reduce the print time from over a day to around 11 hours. Probably even quicker with Klipper.
Upper and lower led holder, lamp holder and upper blank.
20% infill is fine and low quality as they will not be seen in general.
The molds
The higher the quality the better. I just printed standard quality and the result is perfectly fine. The cement will reveal layers lines if you have had a good pour.
All other parts
Standard Quality.
Build video is here
When you have finished your build check out the video below to tune WLED further