Board and case for "Ultracompact set ChessBlock"

Use 0.2 layer height.

Printing the board pieces:

There are 2 board versions, 1 that uses a layer change for the different colors and one that uses zhop to keep the board pieces flat.

layer change board:

• Print 16 board pieces
• add a layer change between layers 3 and 4 for the different colors of tiles.

Z Hop board:

• Slice with NO bed adhesion (no skirt, brim, etc…)
• Add the black piece file, flip it 180 degrees (this is important) and slice
• Add the white piece file to the slicer, and ensure they are lined up (you will ned to flip the white pieces 180 degrees)
• Delete the black pieces
• Add a Z Hop of at 0.8 mm to your slicer and slice the white pieces
• Print the black pieces in whatever color you like
• IT'S IMPORTANT to keep the bed heated after the first pieces print so they don't seperate from the build plate
• Change over the filament, and purge until the color has changed
• Print the white pieces (with the z-hop file)

Printing the case:

Print the top and bottom box pieces using vase mode / spiralize mode.

I printed mine with a 0.6 nozzle. 

If you print this with a 0.4 nozzle you'll need to adjust the 3d model of the box to remove 0.2 from each of the 4 sides of the box top / lid to ensure a snug fit.