Hobby Knife slider replacement - Complex small part
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was wondering if a small complex part would be feasible in simple PLA... and it is.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 375
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I was wondering if a small complex part would be feasible in simple PLA... and it is. This replaces the typical slider piece of a hobby knife, those that use 18 mm width blades. The lock works and it is quite smooth to use in general.
Use CA (super glue) to join the 5 pieces as shown in the animation. It is easier if you have activator spray for the glue.
Print instructions
Unassociated tags: replacement parts
Category: Replacement Parts Summary
I was wondering if a small complex part would be feasible in simple PLA... and it is. This replaces the typical slider piece of a hobby knife, those that use 18 mm width blades. The lock works and it is quite smooth to use in general.
Use CA (super glue) to join the 5 pieces as shown in the animation. It is easier if you have activator spray for the glue.