OnStep MiniPCB Teensy Housing with 4010 Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A housing for the OnStep MiniPCB2 Teensy-based controller with 4010 fan. M3x0.5 heatset inserts for assembly.
- Ocena
- 4 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 2
- Wyświetlenia
- 840
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is a housing for the OnStep MiniPCB2 Controller board using the Teensy 3.2 or Teensy 4.0 arduino board. More details regarding the electronics can be found on the OnStep wiki at https://onstep.groups.io/g/main/wiki/8768
OnStep is an open source telescope go-to controller that utilizes arduino boards to process and control stepper or servo motors that in turn control and direct a telescope. The telescope that I built utilizes an Alt-Az mount (I built the Hadley designed by Maff - https://www.printables.com/model/224383-astronomical-telescope-hadley-an-easy-assembly-hig and this controller is slated for use on the Hadley once I finish modeling and printing gear and stepper mounts for the scope). As a result, labeling on the back panel indicates the stepper axes as Alt and Az.
The housing is 4 pieces - (1) the main body that the board mounts to, (2) the lid which the fan mounts to, (3) a front panel where the power switch, Teensy USB port, smart handcontroller, and LED status lights are located, and (4) a rear panel with PEC, auxilliary and stepper motor ports. I chose to use JST-XHP headers for the stepper motor ports, and the step and f360 files include a very simple pcb to mount the JST-XHP headers with connected pads to solder wires to connect to the screw terminals that I used in place of the RJ45 ports that are optional on the MiniPCB2 board.
Note that I am using a 12v power supply so I was able to directly connect my 12v fan. If the power supply you elect to use outputs voltage different than your fan's voltage, then you'll need to include some form of power converter. There should be room to glue or otherwise mount a small converter on the underside of the lid.
Printing is straightforward, and everything is designed to be printed without supports. You may have to orient the parts correctly. I'd recommend printing the front and back panels separately from the other parts and placing a pause prior to the last couple of layers for a filament color change so that labeling shows up more clearly. Assembly requires the use of 18 M3x0.5 heat set inserts. Heat set inserts are used for the board mounts, as well as the case assembly.
I've included both step files as well as F360 files (I used F360 for the design) to make remixes easier to change axis labeling, change power switch style, etc. a bit easier.
As always, when working with electronics, there is significant risk of serious bodily harm and damage to your property. I take no responsibility for your use of the models, and you assume all risk of harm. It's your responsibility to understand the risks and to take all necessary precautions.
May you have dark and cloudless skies!
