1 / 6
2x 5015 - Bambu Lab X1C BentoBox Air Filter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix to 2x 5015 radial fans for better static pressure.
- Ocena
- 4,75 / 5
- Polubienia
- 156
- Pobrania
- 658
- Wydruki
- 5
- Wyświetlenia
- 9255
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (13)Wydruki i komentarze (Wydruki: 5) (Komentarze: 18)Remiksy (3)Kolekcje (341)Powiązane
v2 Changes - 2023-06-13
- Increased fan front-to-back tolerances to make assembly easier
- Greatly improved the wiring spacing to prevent damage during assembly/dissassembly
- Added cutout to fit the bottom of X1/X1C
- Increased the Z-height of the Adapter to improve airflow. (Compatible with v1 Base)
Designed to replace the BentoBox Fan Duct and Fan Bracket to support 2x 5015 radial (blower) fans. Ex: https://www.amazon.com/dp/B079BPS9Q8
Same dimensions as the stacked Duct and Fan with matching screw holes and magnet spots. Please see https://www.printables.com/model/272525-bambu-lab-x1c-bentobox-air-filter/files for most instructions.
Printing
- Layer Height: 0.2 - 0.3 mm
- Infill: 20%
- Support: Yes, recommended to have a brim for the inside Fan Adapter vent supports
Assembling
- Install magnets and threaded heat inserts like the original
- Insert the right 5015 fan and route the cable out the left side.
- Carefully route and hold the fan cables while inserting the left fan. If the gap seems tighter on the left fan, then you are likely pinching a cable.
- Splice the fan wires together for power based on original design
- Add the HEPA Filter and Activated-Carbon components on top
Please enjoy the .step file.