1 / 4
Classic Zipper Pull for Zippy Bag Clip and Zippy Fidget — zdjęcie 1
1 / 4

Classic Zipper Pull for Zippy Bag Clip and Zippy Fidget

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement slider for LoboCNC's zipper designs with classic zipper styling.

Ocena
4 / 5
Polubienia
197
Pobrania
806
Wydruki
3
Wyświetlenia
5764
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I loved LoboCNC's zipper bag clip but I wanted it to look more like a standard zipper. This will also work with LoboCNC's Zipper Fidget.

 I scaled a model from David Naoum on MyMiniFactory till it looked good and cut of the crown and pull. I added cylindrical alignment pins for assembly. The two pegs are not equal length of orientation is important. The long peg goes in the through hole.

The parts are all oriented how I printed them. I printed the crown on it's side to make the pegs stronger. I did use a small amount of support just to make sure the larger peg formed well, but it was probably unnecessary.

Super glue or other adhesive is required for attaching the crown to body. If using super glue I recommend the gel type so it can't run.

The zipper in my photos is extra long.

Because David Naoum's model is licensed non-commercial, I have set the license as Attribution—Noncommercial—Share Alike.

Tagi