1 / 4
Desk Lamp, Mood Light and Sunrise Alarm — zdjęcie 1
1 / 4

Desk Lamp, Mood Light and Sunrise Alarm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A multi-purpose desk lamp with sunrise alarm function, a mood light with snooze function and a timer.

Ocena
0 / 5
Polubienia
90
Pobrania
101
Wydruki
0
Wyświetlenia
1681
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial

I designed this desk lamp initially as a sunrise alarm clock for my son to help him waking up in the morning. The lamp starts to glow 30 minutes before wake-up time. Light level and color is continunously adjusted to simulate a sun rise until full brightness is reached. 

Over time more and more features were added to the alarm clock.

By lighting up all LEDs at full brightness level, it works well as a desk lamp. Just note, that the LEDs become pretty warm. I printed the compartment in ASA, which can cope with the heat. However, the heat is hardly conducted away and I am afraid, using this feature extensively will reduce the life of the LEDs.

There are a couple of mood light animations with snooze function (fading out for sleeping). E.g. the flame animation:

A timer function reminds my son that his computer time is over by playing a police signal animation.

Noteworthy design ideas

As MCU I used a XIAO SAMD21 because it features QTouch inputs, which can be used as input button by only touching a conductive area connected to such a pin (and because I had some left in my shelf). All my Octo-Design gadgets have three ventilation slits, but in this device these slits house small plates printed with a conductive filament (Filaflex conductive) and wired to QTouch inputs. This is the simplest to make and best to use solution for user input I have made so far.

Bill of material

  • XIAO SAMD21 from Seeed Studio
  • 0,96" OLED Display with SSD1306 driver and I²C bus
  • DS3231 Real Time Clock module with I²C bus
  • 50cm (75 LEDs) Neopixels or similar 150 LEDs/m strip
  • eventually a buzzer for alarm sound
  • 3x M2x8 screws, nuts and washer to connect wires to the QTouch plates
  • Optional: M3 threaded insets and M3 screws to screw the base and the LED holder together. However, the glass part is simply pushed into the base and locks the LED holder very well in place, so screwing is not necessary

 

Tagi