1 / 1
Christmas Window Decor - Santa Sleight above Houses Silhouettes — zdjęcie 1

Christmas Window Decor - Santa Sleight above Houses Silhouettes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Print it. Place it on the custom stand, or near a wall, or in the window. Enjoy! Ho ho ho!

Ocena
5 / 5
Polubienia
242
Pobrania
1152
Wydruki
11
Wyświetlenia
3707
Oceny
11

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

https://www.buymeacoffee.com/maxt

----------------------

3D print with 5 different houses that can be placed in a window. You have the possibility to change the houses and rotate them in whatever way you please. The houses can also overlap each other if you would like that.

Enjoy! :)

---------------

2mm thick

The model will fit on Prusa Mini+ (180x180)
Feel free to size it up or down as you wish
I strongly suggest sizing it up to fit your entire heat bed as it gives the best result

The best quality is achieved if printed face down

Print: 0.2mm
Nozzle: 0.4mm
Perimeters: 2
Support: Not needed
Brim: Not needed
Infill: 10% (lots of bridging)
Fill pattern: Support Cubic
Solid layers, top: 2
Solid layers, bottom: 2
Minimum shell thickness, top: 0.4mm
Minimum shell bottom, top: 0.4mm
Seam position: Rear
These settings will save you at least 40% of the filament, and it will produce the same quality print.

A tip: If you want to get this print easily off your heat bed, place the heat bed with the printed model in the freezer for 10 to 30 mins. Take it out, and it should pop off quite easily without any breaks/cracks, as shown on the photo below :)



I've also included a custom stand :)
You'll need 3 stands for each of the houses. Here's a little guide on how to create many instances of the same model/stand: Copy, paste, instances
If you do not want to use the stand (for example if the models will be placed in the window, you can simply cut the bottom part with latches off saving printing time and filament :) See this little guide: Negative volume
Infill: 10%

Happy Printing!

--------------

https://www.buymeacoffee.com/maxt