Sovol SV04 5015 Fan Ducts

REMIX from: https://www.thingiverse.com/thing:5191744

Great Design!

This upgrade will allow the use of 5015 Blower fans on your SV04. 

These fans & ducts may cause worry for those that like loud fans.

Db meter showed a -6Db over stock (+/- 1Db). Now you can really only heard the PSU/MB fans.

Printed in PETG. Anything less would be “uncivilized” and could melt.

HARDWARE NEEDED:

4 - M3 4mm-5mm (button head preferred)- 2 per Mount ( Pics use M3 x 4mm Nylon screws and they hold fine)

5015's fit very snug, but I also used a little E6000 or equivalent - Something to seal, but not permanent for later removal. 

Tree supports only for the mounts touching build plate may be needed, but it is very very minimal

The 40mm Fan Cover does multiple jobs. It mainly acts as a “bumper” just in case your extruders decide to collide - protects the left extruder 5015 from colliding with extruder 2 5015. They can easily be mounted using the existing hardware.

WARNING: Using Mirror Mode may cause a collision of the extruders in the middle of the bed so either just use COPY MODE (Duplicate), or USE AT YOUR OWN RISK. 

After further testing Mirror Mode, as long as your Bed settings are set stock (115X 302Y), then you should be ok. I tested up to a 113mm model (No Brim/Skirt) with no issues. Any larger and the model would not fit on the build plate in CURA.

There stacks can also help:

https://www.printables.com/model/469552-5015-fan-short-velocity-stack

Please post Makes and Donate if your able. I do this for the love of the community, but any contributions are greatly appreciated.