Merry Christmas Gnome - Napkin Decoration

https://www.buymeacoffee.com/maxt

----------------------

This model goes well with another way to decorate the napkins - Christmas Napkin Ring Set, 8 different pieces

Usage:

• Place it on a maroon napkin for your festive Christmas table
• Place it on the attached stand for freestanding use as a decoration
• Use adhesive tape to put it on the window (scale up if you want to)
• Glue it to a Christmas card's front
• Use it as a bookmark for your favorite Christmas book
• Use it as a coaster for your favorite Christmas drink, eggnog or not
• Tape it to your forehead!
• Post your suggestion in the comments and it might end up here! :)

2mm thick to ensure sturdiness so it can be used year after year. People will play with it at the table, so you want it to be sturdy.

The model will fit on Prusa Mini+ (180x180)
Feel free to size it up or down as you wish

The best quality is achieved if printed face down (3MF and GCODE are already face down)

Print: 0.2mm
Nozzle: 0.4mm
Perimeters: 2
Support: Not needed
Brim: Not needed
Infill: 20% (just to ensure sturdiness)
Fill pattern: Support Cubic
Solid layers, top: 2
Solid layers, bottom: 2
Minimum shell thickness, top: 0.4mm
Minimum shell bottom, top: 0.4mm
Seam position: Rear
These settings will save you at least 40% of the filament, and it will produce the same quality print.

A tip: If you want to get this print easily off your heat bed, place the heat bed with the printed model in the freezer for 10 to 30 mins. Take it out, and it should pop off quite easily without any breaks/cracks, as shown on the photo below :)




Happy Printing!

--------------

https://www.buymeacoffee.com/maxt