1 / 1
2KG Filament holder extension V2 for Prusa Enclosure
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Version 2 of the model to fit Prusa enclosure filament holder
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 448
- Wydruki
- 10
- Wyświetlenia
- 2185
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 10) (Komentarze: 18)Remiksy (1)Kolekcje (52)Powiązane
I had issues with the original design in the Original Prusa enclosure. It wasn't wide enough, so the spool wouldn't spin properly and would bind.
I also had the ABS split when I put on the original stick, so made that a bit larger on this design.
Added angles to avoid supports if you print flat side down.
I used ABS as it is inside the original Prusa enclosure and PLA goes a bit funny after a long time. Black ABS is now my go to anyway with enclosure.
Thanks to BastiiF for the original design.