Cute ornament gnome
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cute ornament gnome with a formable beard.
- Ocena
- 4,923 / 5
- Polubienia
- 245
- Pobrania
- 830
- Wydruki
- 20
- Wyświetlenia
- 3771
- Oceny
- 13
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Print each part, see print instructions.
Cut away the wall from the beard with a knife.
Assemble the parts and then use a hair dryer/hot tap water to slowly heat up the beard while you use a hand to form it.
For most control, use water. For crazy beard, use hair dryer.
Be careful not to burn yourself.
Tip: put the hair dryer on the edge of a table so you can use both hands.
After you have formed the beard, you can use scissors to make some final adjustments.
Print instructions
All parts has been optimized to not need any support. The overhang on the body is 45deg.
The beard should be printed with a 0.2 layer height.
The beard prints better with the classic perimeter generator in prusaslicer.
Support / Reseller
If you want to support me or sell my models, take a look at my Patreon:
https://www.patreon.com/thomash3d
You can also send me a tip on paypal:
Misc
Check out the original standing version:
https://www.printables.com/model/92035-bearded-christmas-gnome
Updated 2022-12-12: Added chamers to body and hat.