Sunlu S1 Filament Dryer Lid Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple support that slides on to the back to keep the lid from going all the way back.
- Ocena
- 4,912 / 5
- Polubienia
- 192
- Pobrania
- 1331
- Wydruki
- 65
- Wyświetlenia
- 3347
- Oceny
- 57
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Was able to pick up the Sunlu S1 at a discount, but was annoyed the lid would go flying back every time I opened it and was concerned it was going to shatter.
The updated design can be printed without supports. I recommend printing with a minimum of 3 perimeters.
Update 01.28.2023:
Thank you to those who posted makes. Based on input I have updated the design with the following
- I decreased the lid open angle to help decrease the chance of tip over when dryer is empty.
- Chamfered edges to reduce sharp points. And allowed for the print to be printed without supports.
Notes on original design:
Minimal supports needed on the hooks only. Paint supports on, set overhand threshold below 45%, or use the provided print file. Whatever works for you.