Orange Pi 5 case and carrier _update
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple case and experimentation carrier board for the Orange Pi5
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 483
- Wydruki
- 1
- Wyświetlenia
- 4400
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
Simple case designed for the orange pi 5 sbc.
Designed in Fusion 360.
Print the lid upside down, the embossed logo should not require support if cooling is sufficient. For the case itself, supports under the holes is advised as these span quite some distance.
For assembly, you only need 4 2.5mm screws of 3mm long to attach the sbc in the bottom half. It is a tight fit to get the board in, be careful not to stress it to much. Especially the HDMI port and the button next to the SD slot are protruding quite some distance and can get caught on the reinforcement ribs.
UPDATE 2023/01/02: increased the space around the pcb a tad and added more ventilation (bottom case for nvme and lid. Added lid version with and without mounting holes for a 30mm an 40mm fan)
Update 2023/01/04: Changed the position of the ventilation slots as they were in the wrong position.
Update 2023/01/06: added some pictures