1 / 2
Headphone cord slider for Moondrop CHU (1.7mm cable) — zdjęcie 1
1 / 2

Headphone cord slider for Moondrop CHU (1.7mm cable)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A slider for Moondrop CHU headphone cables (maybe any headphone with cables 1.7mm in width).

Ocena
5 / 5
Polubienia
21
Pobrania
203
Wydruki
1
Wyświetlenia
1137
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted a slider for my Moondrop CHU headphone wires so they would be more taut around my ears by allowing me to cinch the cables down under my chin.

Took me 4 tries to refine, but the dimensions are tight enough to keep the cables in the slider and in place where you set them, but loose enough to allow the it to slide up and down the cords for adjustment.

The CHU cables measure at 1.7mm, so if you have a set of headphones that are the same size then it could work for those too, but I've only tested on my CHUs.

Printed in PLA with the channels standing vertical at 0.2mm and 100% infill. Dimensions are 10mm x 10mm x 6mm (Cura blew it up to 100mm when I imported the file, so just make sure to adjust that setting).

Tagi