Wake-Up Light Alarm w/ MiLight
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I leveraged realifeonhold's Wake-Up Light Alarm Clock idea and rather than use a dimmer switch w/ Tasker control, I…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 224
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I leveraged realifeonhold's Wake-Up Light Alarm Clock idea and rather than use a dimmer switch w/ Tasker control, I used a spare MiLight RGBW light bulb and Node-Red to control it.
I had a spare globe light fixture installed by the builder from when we moved into our house. It was slightly larger (123MM diameter) so I needed to scale the original design to 106.5% to fit and since my fixtures needed a ground, I included the plate from the original mount. I cut the power cord off an old broken hot glue gun.
The flow for Node-Red was developed by strelniece and available here: (http://flows.nodered.org/flow/ff0091dffe5b121e0663). It uses MQTT to UDP to broadcast to a MiLight hub. Adding inject nodes to MQTT out will allow you to schedule. This flow changes colors from red to yellow to white over about 30 minutes.
Print instructions
Category: Decor Summary
I leveraged realifeonhold's Wake-Up Light Alarm Clock idea and rather than use a dimmer switch w/ Tasker control, I used a spare MiLight RGBW light bulb and Node-Red to control it.
I had a spare globe light fixture installed by the builder from when we moved into our house. It was slightly larger (123MM diameter) so I needed to scale the original design to 106.5% to fit and since my fixtures needed a ground, I included the plate from the original mount. I cut the power cord off an old broken hot glue gun.
The flow for Node-Red was developed by strelniece and available here: (http://flows.nodered.org/flow/ff0091dffe5b121e0663). It uses MQTT to UDP to broadcast to a MiLight hub. Adding inject nodes to MQTT out will allow you to schedule. This flow changes colors from red to yellow to white over about 30 minutes.
Print Settings
Printer: Qidi Tech I
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 40%
Notes:
PLA - took about 3 hours to print and is very solid - great design by realifeonhold
Post-Printing
Connected wires:
Bare copper (ground) to ground plate mounted on base
Black (hot) to smaller plug side
White (neutral) to larger plug side
Used 2 screws to attach the base, ground plate and light fixture