1 / 10
Homematic HM-LC-Sw4-PCB DIN Rail Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A base plate for the Homematic HM-LC-Sw4-PCB 4-Channel Switch Actuator to be able to mount it to a DIN rail
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 565
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (13)Powiązane
An alternative base plate for the Homematic HM-LC-Sw4-PCB 4-Channel Switch Actuator using the https://www.printables.com/model/64242-din-rail-clip to be able to mount it to a DIN rail. The base plate requires two DIN rail clips that can be mounted in both directions.
Print Settings
- Print the base plate with the flat side facing down towards the build plate.
- No supports needed.
- If your printer has a good build plate adhesion you won't need a brim to prevent the part from warping.
Assembly
- Clip the two DIN rail clips to the DIN rail.
- Use two screws per DIN rail clip to mount them to the base plate. I did use some 3x16mm countersunk screws.
- Make sure the screws are flat with the base plate surface to prevent any short circuit with the PCB.
- Screw the PCB to the base plate using the four original screws.
- Use the original cover to close off the case with using the two original screws.