1-1/8" Steerer Tube Headset Spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1-1/8" Steerer Tube Headset Spacer in three heights.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 154
- Wydruki
- 2
- Wyświetlenia
- 994
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
There are three heights for the spacer - 16mm, 21mm, 26mm, measured from the two flat contact surfaces. I've only printed the 21mm. If you notice any flaws let me know and I'll try to fix it.
The shape and height of the shielding cone may not work with all headsets. It will depend on the compression cone or seal underneath. The included picture of it installed is on an Orbea's headset. So far no issues.
I've included a 1mm shim, in case the cone does not clear the frame. You can also manually cut it in your slicer, or sand it off after print.
Remember to print at 100% infill because this is all under compression. No supports necessary if you print with the surface that comes in contact with the stem towards the print plate.
Mine is printed with Prusament PC-Carbon Blend.